Memory error

Replies to This Discussion

Permalink Reply by Rafael del Molino on October 18, 2011 at 12:27pm

Hi Thomas,

 

What parameters are you using? May you do a snapshot of the parameters window?

 

Usually the problem of memory is because RhinoNest find "bad solutions". 

 

Thanks,

 

Rafael del Molino

TDM Solutions SL

• ▶ Reply

Permalink Reply by Thomas Brandwijk on October 18, 2011 at 12:37pm

Here is a snapshot, but I tried a lot of different combinations and the all give an error.

Attachments:

• 5mm nest wizard 4.jpg, 259 KB

• ▶ Reply

Permalink Reply by Thomas Brandwijk on October 18, 2011 at 3:21pm

Hello!

 

Problem solved! I installed service pack 3 and it worked. But now I have some parts that overlap, has that anything to do with the new option "optimize polylines"?

 

 

• ▶ Reply

Permalink Reply by Thomas Brandwijk on October 21, 2011 at 3:53pm

Helle Rafael,

 

After the installation of service pack 3 al lot of errors disappeared, but for this file the errors showed up again. Can you give me some advice? 

All the lines are closed, checked, groups are made, so I don't know what I am doing wrong!!

 

 

Greetings,

Thomas

Attachments:

• 5mm nest.3dm, 2.7 MB

• ▶ Reply

▶ Reply to Discussion